Gas Hot Water Repairs & Replacement in Drummoyne NSW

A young family’s bathroom tap was running dangerously hot, and a new tempering valve brought the delivery temperature back to a safe level. Tempering and TPR valve replacement form part of a wider hot water service that includes emergency repairs, pilot and ignition faults, thermocouples and gas valves and leaking cylinders. Our gasfitters also service units with anode and burner checks and install new storage and continuous flow units with gas line and flue upgrades for natural gas or LPG.

Treat it as an emergency if you have no hot water at all, if water is pooling around the cylinder, or if you can smell gas anywhere near the unit. Any of those warrants an urgent call rather than an online booking for later in the week, and after-hours slots are held for them.

We hold full gasfitting licences, so distance is a matter of scheduling rather than qualification. Local suburbs are our daily run, with regional and rural jobs booked around them.

Storage systems are priced by capacity in litres, continuous flow units by flow rate in litres per minute. The larger the unit in either case, the higher the cost of the hardware. Beyond the unit, labour depends on whether connections, flue and gas line can be reused, so a free written quote after a site visit is the only accurate figure.

A thermocouple is a small probe that sits in the pilot flame and generates a tiny electrical signal while it is hot, and that signal is what holds the gas valve open. As the probe wears, the signal weakens and the valve shuts the gas off even though the flame looked fine a moment earlier. That is the most common reason a pilot on a storage hot water system will not stay lit, and a licensed gasfitter can test and replace it in a single visit.

Imagine a leak or damage occurring while a tradesperson is working at your place. Our public liability insurance exists for exactly that situation, so you are not left carrying the cost. Pair that with licensed gasfitters on every job and a compliance certificate at the end and you have full protection.

Imagine a system that still works but has become too small since the family grew, with showers running cold most mornings. There is nothing to repair here, because the unit is doing exactly what it was built to do. The fix is a larger storage capacity or a continuous flow unit sized to the household, and we would help you choose between them. An undersized system is one of the clearest cases for replacement.

A new installation should leave the area as tidy as it was found. Drained water is handled properly, packaging comes away, and the old unit is removed for recycling rather than left beside the house. All of that is part of the few hours a standard replacement takes, not an extra appointment.

For a landlord booking a service on a rental property the visit doubles as a dated safety record. We test for gas leaks and carbon monoxide, check the flue has a proper draught, operate the TPR valve, and confirm the tempering valve is delivering a maximum of 50 degrees Celsius to the bathrooms. The burner is cleaned and its flame checked, gas pressure is tested at the regulator, the ignition is tested, and the written report gives you and your property manager a clear record of the unit’s condition for your files.

Both the equipment and the labour are protected. The unit is covered by its manufacturer’s warranty, and our workmanship guarantee covers the installation or repair we carried out. Keep the invoice and the compliance certificate together, since the manufacturer will ask for proof of licensed installation if you ever need to claim.

There is no need to panic when the hot water drops out. The pilot may simply have been blown out by a gust of wind, the LPG bottle may be empty or someone may have bumped the isolation valve, and none of those mean anything is broken. Have a quick look at those three things and call a licensed gasfitter if the problem is not that simple.

The honest answer is that it depends on how your household uses hot water. Continuous flow never runs out but needs a gas supply sized for a high MJ/h input and solid water pressure to deliver its rated litres per minute. Storage copes with heavy simultaneous demand in a straightforward way and is usually the simpler like-for-like swap when a cylinder is already in place.